Aggelies

A commonly used standard to quantify finished quality of elevated and slabon- ground slabs is the ASTM Standard E The procedure outlines the method of . slab-on-ground slabs is the ASTM Standard, ASTM E The procedure outlines the method of profiling finished concrete to determine the flatness (FF) and. ASTM E Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers.

Author: Zukazahn Zulkile
Country: Belarus
Language: English (Spanish)
Genre: Relationship
Published (Last): 12 August 2010
Pages: 483
PDF File Size: 7.86 Mb
ePub File Size: 20.45 Mb
ISBN: 932-3-77032-202-5
Downloads: 33303
Price: Free* [*Free Regsitration Required]
Uploader: Dourr

No other units of measurement are included in this standard. Repeat for several runs, as shown above.

Module 6.2: Floor Flatness and Level ASTM E1155 with BuildIT Construction

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Next we will create a line for each run, the end result will appear as shown: Select all the sample lines.

Click on the Report tab and click on Generate Report. Such direct simulation measurements eliminate the inherent uncertainties of statistical sampling and provide profile information immediately applicable to the correction of the surface in way of the future traffic.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Historical Version s – view previous atsm of standard.

  ARMY FM 25-101 PDF

These notes and footnotes excluding those in tables and figures shall not be considered as requirements of this test method. To avoid errors, save the current project before attempting the Floor Flatness Analysis.

When prompted specify a location and name for the PDF report. Astmm Lines for Each Run Next we will create a line for each run, the end result will appear as shown: Split cloud Creating lines representing a run. Line Panel for each completed line. Tutorial Download If you would like to download the file used in this article, download the accompanying Training Data and extract its contents to a folder on your PC.

A simple w orkflow from importing the files to producing a report of the surface deviation analysis. When the traffic patterns across a floor are random, as is generally the case evaluation of the floor’s F F Flatness and F L Levelness will necessarily involve a random sampling of the surface, since all of the infinite potential profiles to be seen by the traffic can not possibly be measured.

Construct a polygon line e11155 the area shown below. A simple workflow from importing the files to producing a report of the surface deviation analysis.

Split cloud down to satm area to be analyzed. In these special cases, rather than inferring the condition of the traffic paths from a random sample, it is far more useful to measure each of the traffic paths directly using continuous recording floor profilometer configured to run exactly in the traffic wheel paths.

  LG TONE INFINIM MANUAL PDF

Lines are created to represent runs with traditional equipment. A complete metric companion to Test Method E has been developed, Test Method EM ; therefore, no metric equivalents are shown in this test method. Link to R1155 This link will always route to the current Active version of the standard. If you would w1155 to download the file used in this article, download the accompanying Training Data and extract its contents to a folder on your PC.

Module Floor Flatness and Level ASTM E with BuildIT Construction – FARO┬« Knowledge Base

Generate a Report from the Analysis The command will automatically build a standard report. In those instances when the traffic across a floor will be asmt to specific paths, however, the requirement for random sampling is eliminated, since the floor can indeed be inspected exactly as it will be asmt by all of the traffic.

By now you should have a grasp of the following: By now you should have a grasp of the following:.

Select a start point and then select an end point for the first line. Use the defaults for this exercise.